Cisco A9K-SIP-700 Command Reference Guide

multilink group
To attach a serial interface to a multilink interface bundle, use the multilink group command in interface
configuration mode. To remove a serial interface from a multilink interface bundle, use the no form of this
command.
multilink group bundleID
no multilink group bundleID
Syntax Description
Bundle ID number of the multilink interface, in the format
rack/slot/bay/controllerID/bundleID)
bundleID
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writehdlc
Examples
The following examples show how to attach a serial interface to a multilink interface bundle:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1/1/1:0
RP/0/RSP0/CPU0:router(config-if)# multilink group 1
RP/0/RSP0/CPU0:router(config-if)# commit
or
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1/1/1:0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
685
Multilink Commands on the Cisco ASR 9000 Series Router
multilink group

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English