controller (SONET)
To enter SONET/SDH configuration mode so that you can configure a specific SONET controller, use the
controller (SONET) command in global configuration mode. To return to the default state, use the no form
of this command.
controller [preconfigure] sonet interface-path-id
no controller [preconfigure] sonet interface-path-id
Syntax Description
(Optional) Specifies a SONET preconfiguration. Use the preconfigure keyword
only when a modular services card in not physically installed in a slot.
preconfigure
Enters the SONET configuration mode or configures the SONET port controller
specified by interface-path-id.
sonet
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is rack/slot/module/port. The slash between values
is required as part of the notation. An explanation of each component of the naming notation is as follows:
â—¦
rack: Chassis number of the rack.
â—¦
slot: Physical slot number of the line card.
â—¦
module: Module number. A physical layer interface module (PLIM) is always 0.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
857
SONET Controller Commands on the Cisco ASR 9000 Series Router
controller (SONET)
To Next Page
Loading...
Need help?
General
