framing (T1)
To select the frame type for a T1 data line, use the framing command in T1 configuration mode. To disable
T1 framing, use the no form of this command.
framing {esf| sf}
no framing {esf| sf}
Syntax Description
Specifies extended super frame as the T1 frame type. The default is esf.esf
Specifies super frame as the T1 frame type.sf
Command Default
The default is esf.
Command Modes
T1 configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the framing command in configurations in which the router or access server is intended to communicate
with T1 fractional data lines. The service provider determines the framing type required for your T1 circuit.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to select super frame as the T1 frame type:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1)# framing sf
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1006
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
framing (T1)
To Next Page
Loading...
Need help?
General
