lacp non-revertive
To configure the currently active but lower priority port to remain active port even after a higher priority port
is capable of being operational, use the lacp non-revertive command in the bundle interface configuration
mode. To revert to the default configuration, use the no form of this command.
lacp non-revertive
no lacp non-revertive
This command has no keywords or arguments.
Command Default
A higher priority port would become the active port after it becomes operational again.
Command Modes
Bundle interface configuration mode
Command History
ModificationRelease
This command was introduced.Release 5.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, write
Examples
The following example shows how to configure the non-revertive behaviour on an LACP bundle interface.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-if)# lacp non-revertive
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
598
Link Bundling Commands on the Cisco ASR 9000 Series Router
lacp non-revertive
To Next Page
Loading...
Need help?
General
