show aps agents
To display the status of the automatic protection switching (APS) working to protect (WP) distributed
communication subsystem, use the show aps agents command in EXEC mode.
show aps agents
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the show aps agents command to display the status of the APS WP distributed communication subsystem.
The WP communication is critical for the APS functionality. The show aps agents command is typically used
as a debugging aid for unexpected or unusual APS operation.
Displaying the APS operational data is considered of lower priority than the APS operation itself. Because
the information is collected from several sources scattered across the various nodes involved, there is a small
probability that some states will change while the command is being run.
The command should be reissued for confirmation before decisions are made based on the results displayed.
Task ID
OperationsTask ID
readsonet-sdh
Examples
The following is sample output from the show aps agents command:
RP/0/RSP0/CPU0:router# show aps agents
SONET APS Manager working-Protect (WP) connections:
Remote peer (192.168.3.2 - auto) is up:
Group 6 [P.Ch0] 192.168.3.2 === Manager --- SONET6_0 (node6) --- [W.Ch1]
Remote peer (10.1.1.1) is up:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
895
SONET Controller Commands on the Cisco ASR 9000 Series Router
show aps agents
To Next Page
Loading...
Need help?
General
