================================================================================
Interface state: Up MAC address: 6655.4433.2211
Peer MEPs: 1 up, 0 with errors, 0 timed out (archived)
CCM generation enabled: Yes, 1s (Remote Defect detected: No)
CCM processing offloaded to software
)
Sending disabled on local standby MEP
CCM defects detected: Defects below ignored on local standby MEP
I - Wrong interval
V - Wrong level
AIS generation enabled: No
Sending AIS: No
Receiving AIS: No
Packet Sent Received
------ ---------- ----------------------------------------------------------
CCM 0 67890 (out of seq: 6, discarded: 10)
LBM 0 1
LBR 0 2 (out of seq: 0, with bad data: 0)
AIS 0 3
LCK - 4
Domain bar (level 3), Service boz
Down MEP on GigabitEthernet102/1/0/0.345, MEP-ID 200
================================================================================
Interface state: Up MAC address: 1122.3344.5566
Peer MEPs: 0 up, 0 with errors, 0 timed out (archived)
CCM generation enabled: No
AIS generation enabled: No
Sending AIS: No
Receiving AIS: No
No packets sent/received
Related Commands
DescriptionCommand
Displays a list of local maintenance points.show ethernet cfm local maintenance-points, on
page 330
Displays information about maintenance end points
(MEPs) for peer MEPs.
show ethernet cfm peer meps, on page 339
Sends Ethernet CFM traceroute messages to generate a
basic.
traceroute ethernet cfm, on page 415
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
338
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet cfm local meps
To Next Page
Loading...
Need help?
General
