Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to enter WAN PHY controller configuration mode:
RP/0/RSP0/CPU0:router # configure
RP/0/RSP0/CPU0:router(config)# controller wanphy 0/6/0/0
RP/0/RSP0/CPU0:router(config-wanphy)#
Related Commands
DescriptionCommand
Displays alarms, registers, and module information for a
10-Gigabit Ethernet WAN PHY controller.
show controllers wanphy, on page 1105
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1101
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
controller wanphy
To Next Page
Loading...
Need help?
General
