Examples
The following example shows how to enter channel group configuration mode for channel group number 5
and change the speed of the underlying DS0s in the channel group to 56 kbps:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1-channel_group)# speed 56
The following example shows how to associate DS0 time slots 1, 6, 8, 9, and 10 to channel group 5:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1-channel_group)# timeslots 1:6:8-10
Related Commands
DescriptionCommand
Enables a BERT pattern on a T3/E3 or T1/E1 line or an individual
channel group.
bert pattern, on page 947
Selects the frame type for an E1 data line.framing (E1), on page 1002
Selects the frame type for a T1 data line.framing (T1), on page 1006
Sets the mode of the T3/E3 or T1/E1 controller.mode, on page 1029
Specifies the speed of the underlying DS0s in a channel group.speed (DS0), on page 1067
Associates one or more DS0 time slots to a channel group and create
an associated serial subinterface.
timeslots, on page 1069
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
958
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
channel-group
To Next Page
Loading...
Need help?
General
