Dell N1100-ON User Manual

Dell EMC Networking CLI 109
Ethernet Configuration
ip arp inspection validate Enables additional validation checks like source
MAC address validation, destination MAC
address validation or IP address validation on
the received ARP packets.
GC
ip arp inspection vlan Enables Dynamic ARP Inspection on a single
VLAN or a range of VLANs.
GC
permit ip host mac host Configures a rule for a valid IP address and
MAC address combination used in ARP packet
validation.
ARPA
show arp access-list Displays the configured ARP ACLs with the
rules.
PE
show ip arp inspection Displays the Dynamic ARP Inspection
configuration.
PE
12 Enabled Disabled Displays the Dynamic ARP Inspection
configuration on all the VLANs in the given
VLAN range.
PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
clear counters Clears statistics on an interface or globally. PE
description Adds a description to an interface. IC
flowcontrol Configures the flow control on a given interface. GC or
IC
interface Enters the interface configuration mode to
configure parameters for an interface.
GC or
IC
interface range Enters the interface configuration mode to
execute a command on multiple ports at the
same time.
GC or
IC or
IR
link debounce time Configures the debounce timer for one or
multiple interfaces.
IC or
IR
Command Description Mode
a

Dell N1100-ON Specifications

General

Brand	Dell
Model	N1100-ON
Category	Switch
Language	English