Layer 2 Switching Commands 612
console(config-vlan2000)#exit
console(config)#mvr vlan 2000
console(config)#interface gi1/0/24
console(config-if-Gi1/0/24)#switchport mode trunk
console(config-if-Gi1/0/24)#switchport trunk native vlan 2000
console(config-if-Gi1/0/24)#switchport trunk allowed vlan add 2000
console(config-if-Gi1/0/24)#mvr
console(config-if-Gi1/0/24)#mvr type source
console(config-if-Gi1/0/24)#mvr vlan 2000 group 239.1.1.1
show mvr
Use the show mvr command to display global MVR settings.
Syntax
show mvr
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec, Global Configuration mode and all Configuration submodes
User Guidelines
The following table lists the completion messages.
The following table explains the output parameters.
Message Type Message Description
Successful Completion Message None
Error Completion Message MVR disabled
Parameter Description
MVR Running MVR running state. It can be enabled or
disabled.
MVR Multicast VLAN Current MVR multicast VLAN. It can be in
the range from 1 to 4093.
To Next Page
Loading...
Need help?
General
