Security Commands 926
Example
This example globally configures the format of the MAC address sent in the
Calling-Station-Id attribute and the User-Name attribute when using MAC
based authentication to IETF lower case. It also configures interface Gi1/0/1
to use MAB. MAB must be configured on the switch in an active
authentication list, IEEE 802.1X must be configured, and a RADIUS server
must also be configured.
console(config)#radius-server attribute 31 mac format ietf lower-case
console(config)#interface gi1/0/1
console(config-if-Gi1/0/1)#dot1x port-control mac-based
"console(config-if-Gi1/0/1)#dot1x mac-auth-bypass"
radius-server deadtime
Use the radius-server deadtime command to configure the minimum amount
of time to wait before attempting to recontact an unresponsive RADIUS
server. To set the deadtime to 0, use the no form of this command.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
• deadtime — Length of time in minutes, for which a RADIUS server is
skipped over by transaction requests. (Range: 0–2000 minutes). Deadtime
is used to mark an unavailable RADIUS server as dead until this user-
configured time expires. Deadtime is configurable on a RADIUS server
basis.
Default Configuration
The default dead time is 0 minutes.
Command Mode
Global Configuration mode
To Next Page
Loading...
Need help?
General
