Layer 2 Switching Commands 556
console(config-if-Gi1/0/3)#lldp notification
lldp notification-interval
Use the lldp notification-interval command in Global Configuration mode
to limit how frequently remote data change notifications are sent. To return
the notification interval to the factory default, use the no form of this
command.
Syntax
lldp notification-interval interval
no lldp notification-interval
• interval — The smallest interval in seconds at which to send remote data
change notifications. (Range: 5–3600 seconds)
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to set the interval value to 10 seconds.
console(config)#lldp notification-interval 10
lldp receive
Use the lldp receive command in Interface Configuration mode to enable the
LLDP receive capability. To disable reception of LLDPDUs, use the no form
of this command.
Syntax
lldp receive
To Next Page
Loading...
Need help?
General
