Switch Management Commands 2158
asset-tag
Use the asset-tag command in Global Configuration mode to specify the
switch asset tag. To remove the existing asset tag, use the no form of the
command.
Syntax
asset-tag [unit] tag
no asset-tag [unit]
• unit — Switch number. (Range: 1–12)
• tag — The switch asset tag.
Default Configuration
No asset tag is defined by default.
Command Mode
Global Configuration mode
User Guidelines
The asset-tag command accepts any printable characters for a tag name
except a question mark. Enclose the string in double quotes to include spaces
within the name. The surrounding quotes are not used as part of the name.
The CLI does not filter illegal characters and may accept entries up to the
first illegal character or reject the entry entirely.
Example
The following example specifies the switch asset tag as 1qwepot. Because the
unit parameter is not specified, the command defaults to the master switch
number.
console(config)# asset-tag 1qwepot
–
show hardware
profile
show switch update bootcode
To Next Page
Loading...
Need help?
General
