Layer 3 Routing Commands 1719
User Guidelines
This command has no user guidelines.
Example
The following example configures the area 1 NSSA so that summary LSAs are
not advertised into the NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa no-summary
area nssa translator-role
Use the area nssa translator-role command in Router OSPFv3 Configuration
mode to configure the translator role of the NSSA. Use the no form of the
command to remove the configuration.
Syntax
area areaid nssa translator-role {always | candidate}
no area areaid nssa translator-role
• areaid — Valid OSPF area identifier.
• always — Causes the router to assume the role of the translator the instant
it becomes a border router.
• candidate — Causes the router to participate in the translator election
process when it attains border router status.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
Need help?
General
