Switch Management Commands 2051
debug lacp
Use the debug lacp command to enable tracing of LACP packets received and
transmitted by the switch. Use the “no” form of this command to disable
tracing of LACP packets.
Syntax
debug lacp packet
no debug lacp packet
Default Configuration
Display of LACP traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug lacp packet
debug mldsnooping
Use the debug mldsnooping command to trace MLD snooping packet
reception and transmission. The receive option traces only received MLD
snooping packets and the transmit option traces only transmitted MLD
snooping packets. When neither keyword is used in the command, then all
MLD snooping packet traces are dumped. Vital information such as source
address, destination address, control packet type, packet length, and the
interface on which the packet is received or transmitted is displayed on the
console. Use the “no” form of this command to disable tracing of MLD
Snooping packets.
To Next Page
Loading...
Need help?
General
