Layer 3 Routing Commands 1361
show ip bgp neighbors policy
This command displays the inbound and outbound IPv4 policies configured
for a specific peer. The output distinguishes policies that are configured on
the peer itself and policies that the peer inherits from a peer template.
Syntax
show ip bgp [vrf vrf-name] neighbors ip-address policy
•
vrf vrf-name
— Displays the aggregate address information associated
with the named VRF.
• ip-address—The IPv4 address of a neighbor can optionally be specified to
limit the output to a single neighbor.
Default Configuration
By default, information about the global VRF is shown.
Command Mode
Privileged Exec mode, Global Configuration mode and all sub-modes
User Guidelines
If the vrf-name argument is specified, information pertaining to that VRF is
displayed.
The following fields are displayed.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Fields Description
Neighbor The peer address of a neighbor.
Policy A neighbor-specific BGP policy.
Template If the policy is inherited from a peer template, this field
lists the template name.
To Next Page
Loading...
Need help?
General
