Layer 3 Routing Commands 1466
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
Command Mode
Global Configuration mode, Virtual Router Configuration mode
User Guidelines
There are no user guidelines for this command.
When in Virtual Router Configuration mode, this command operates within
the context of the virtual router instance. When in Global Configuration
mode, the command operates on the global router instance.
Virtual Router Configuration mode is only available on the
N3000/N3100/N4000 switches.
Example
console(config)#ip icmp error-interval 1000 20
ip netdirbcast
Use the ip netdirbcast command in Interface Configuration mode to enable
the forwarding of network-directed broadcasts. When enabled, network
directed broadcasts are forwarded. When disabled they are dropped. Use the
no form of the command to disable the broadcasts.
Syntax
ip netdirbcast
no ip netdirbcast
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
To Next Page
Loading...
Need help?
General
