Layer 2 Switching Commands 446
show green-mode interface-id
Use the show green-mode interface-id command to display the green-mode
configuration and operational status of the port. This command is also used
to display the per port configuration and operational status of the green-
mode. The status is shown only for the modes supported on the
corresponding hardware platform whether enabled or disabled.
Syntax
show green-mode interface-id
•
interface-id
—An Ethernet interface identifier. See Interface Naming
Conventions for interface representation.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec, Global Configuration mode and all Configuration submodes
User Guidelines
This command output provides the following information.
Term Description
Energy Detect
Energy-detect
admin mode
Energy-detect mode is enabled or disabled.
Energy-detect
operational status
Energy detect mode is currently active or inactive. The energy
detect mode may be administratively enabled, but the
operational status may be inactive. The reasons for the
operational status are described below.
To Next Page
Loading...
Need help?
General
