Layer 2 Switching Commands 708
size to ½ the difference between the previous size and the current
instantaneous queue size, set the weighting constant to 1. To update the
current queue size to 1/4 the difference between the previous size and the
current instantaneous queue size, set the weighting constant to 2, ....
The average queue size is calculated for each physical interface
independently.
redirect
Use the redirect command in Policy-Class-Map Configuration mode to
specify that all incoming packets for the associated traffic stream are
redirected to a specific egress interface (physical port or port-channel).
NOTE: This command is not available on the N1500 Series switches.
Syntax
redirect interface
• interface — Specifies any valid interface. Interface is Ethernet port or
port-channel (Range: po1-po32 or gi1/0/1-gi1/0/24)
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to redirect incoming packets to port
Gi1/0/1.
console(config-policy-classmap)#redirect gi1/0/1
To Next Page
Loading...
Need help?
General
