Layer 2 Switching Commands 319
isdp timer
The isdp timer command sets period of time between sending new ISDP
packets. The range is given in seconds. Use the “no” form of this command to
reset the timer to the default.
Syntax
isdp timer time
no isdp timer
•
time
—The time in seconds (range: 5–254 seconds).
Default Configuration
The default timer is 30 seconds.
Command Mode
Global Configuration mode
User Guidelines
Configuring the timer to a low value on a large number interfaces may affect
system processing due to CPU overload. Use the show process cpu command
to examine the system load.
Example
The following example sets the isdp timer value to 40 seconds.
console(config)#isdp timer 40
show isdp
The show isdp command displays global ISDP settings.
Syntax
show isdp
Default Configuration
There is no default configuration for this command.
To Next Page
Loading...
Need help?
General
