Layer 3 Routing Commands 1507
VLAN ID IP Address Subnet Mask
------- --------------- ---------------
10 0.0.0.0 0.0.0.0
20 0.0.0.0 0.0.0.0
show route-map
Use this command to display the route maps.
Syntax
show route-map map-name
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
For each route map, the match count is shown in terms of number of packets
and number of bytes. This counter displays the match count in packets and
bytes when a route map is applied. When a route map is created/removed
from interface, this count is shown as zero. The following is an example of the
behavior of counters as well as how they are displayed when a route-map is
applied and removed from interface:
console# show route-map test
route-map test, permit, sequence 10
Match clauses:
ip address prefix-lists: orange
Set clauses:
set metric 50
console #show ip policy
Interface Route-Map
------------ -----------------------------------------
To Next Page
Loading...
Need help?
General
