Audio Visual Bridging Commands 1092
MSRP must also be enabled globally in order to become operational.
This command is only available on the N4000 Series switches.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example enables MSRP on interface Gi1/0/1
console(config)#interface gi1/0/1
console(config-if-Gi1/0/1)#msrp
msrp boundary-propagate
Use this command to configure the IEEE 802.1Qav boundary propagation.
Use the no form of the command set the class configuration to the default.
Syntax
msrp boundary-propagate
no msrp boundary-propagate
Default Configuration
Talkers on a boundary port are ignored by default.
Command Mode
Global Configuration mode
User Guidelines
Use the boundary propagation configuration to administratively define the
edge of the IEEE 802.1Qav domain. Disable boundary propagation to ignore
talkers on boundary ports.
Boundary propagation can only be configured when MSRP is globally
disabled.
Command History
Introduced in version 6.2.0.1 firmware.
To Next Page
Loading...
Need help?
General
