Switch Management Commands 2042
Enabling one of the packet type options enables packet tracing in both the
inbound and outbound directions.
Debug commands should be used with caution. Switch behavior may be
adversely affected by the additional processing load incurred by enabling
debug output.
If the vrf-name is specified, information pertaining to that VRF is displayed.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console#debug ip bgp 10.27.21.142 events
debug ip dvmrp
Use the debug ip dvmrp to trace DVMRP packet reception and transmission.
The receive option traces only received DVMRP packets and the transmit
option traces only transmitted DVMRP packets. When neither keyword is
used in the command, all DVMRP packet traces are dumped. Vital
information such as source address, destination address, control packet type,
packet length, and the interface on which the packet is received or
transmitted is displayed on the console.
Syntax
debug ip dvmrp packet [receive | transmit]
no debug ip dvmrp packet [receive | transmit]
Default Configuration
Display of DVMRP traces is disabled by default.
Command Mode
Privileged Exec mode.
To Next Page
Loading...
Need help?
General
