Layer 2 Switching Commands 513
Default Configuration
Listener message suppression is enabled by default.
Command Mode
Global Configuration mode.
User Guidelines
MLD listener message suppression is equivalent to IGMP report suppression.
When MLD listener message suppression is enabled, the switch only sends
the first report received for a group in response to a query. Listener message
suppression is only applicable to MLDv1.
Example
console(config)#ipv6 mld snooping vlan 10 listener-message-suppression
ipv6 mld snooping vlan last-listener-query-
interval
The ipv6 mld snooping vlan last-listener-query-interval command sets the
number of seconds after which a host is considered to have left the group.
This value must be less than the MLD Query Interval time value. The range
is 1 to 25 seconds.
Syntax
ipv6 mld snooping vlan vlan-id last-listener-query-interval time
no ipv6 mld snooping vlan vlan-id last-listener-query-interval
• vlan-id — A VLAN identifier (Range 1-4093).
• time — The number of seconds after which a host is considered to have
left the group. (Range: 1–25 seconds)
Default Configuration
The default maximum response time is 10 seconds.
Command Mode
Global Configuration mode
To Next Page
Loading...
Need help?
General
