Switch Management Commands 1997
power inline management
Use the power inline management command in Global Configuration mode
to set the power management type. This command is used along with the
power inline priority
command. Use the no form of this command to set the
management mode to the default.
Syntax
power inline management [unit unit-id]{dynamic | static | class}
no power inline management [unit unit-id]
• dynamic—Dynamic power management
• static—Static power management
• class—Class-based power management
• unit-id—A stack unit ID.
Default Configuration
Default management is dynamic.
Command Mode
Global Configuration
User Guidelines
If no unit is specified, all members of the stack are configured. Static,
dynamic and class-based modes differ in how the available power is calculated
and how much power may be delivered to the Powered Device. Refer to the
PoE section in the User’s Configuration Guide for information on Powered
Device detection, power allocation methods, and the PoE guard band.
Example
In the following example, no port is specified so the command displays global
configuration and status of all the ports. Configure the global power
management scheme as dynamic with dot3at+legacy detection and enable
PoE capability on ports Gi1/0/1-10.
console(config)#power inline management dynamic
console(config)#power inline detection dot3at+legacy
To Next Page
Loading...
Need help?
General
