Layer 3 Routing Commands 1733
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPFv3 Configuration
mode to configure the external LSDB limit for OSPF. If the value is -1, then
there is no limit. When the number of non-default AS-external-LSAs in a
router's link-state database reaches the external LSDB limit, the router enters
overflow state. The router never holds more than the external LSDB limit
non-default AS-external- LSAs in it database. The external LSDB limit
MUST be set identically in all routers attached to the OSPF backbone and/or
any regular OSPF area.
Syntax
external-lsdb-limit limit
no external-lsdb-limit
• limit — External LSDB limit for OSPF (Range: -1-2147483647)
Default Configuration
-1 is the default value for limit.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the external LSDB limit at 100 for OSPF.
console(config)#ipv6 router ospf
console(config-rtr)#external-lsdb-limit 100
ipv6 ospf
Use the ipv6 ospf command in Interface Configuration mode to enable
OSPF on a router interface or loopback interface.
To Next Page
Loading...
Need help?
General
