Layer 2 Switching Commands 795
protocol group
Use the protocol group command in VLAN Configuration mode to attach a
VLAN ID to the protocol-based group identified by groupid. A group may
only be associated with one VLAN at a time. However, the VLAN association
can be changed. The referenced VLAN should be created prior to the creation
of the protocol-based group except when GVRP is expected to create the
VLAN.
To detach the VLAN from this protocol-based group identified by this
groupid, use the no form of this command.
Syntax
protocol group group-id vlan-id
no protocol group group-id vlan-id
• group-id — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the vlan
protocol group command. To see the group ID associated with the name
of a protocol group, use the show port protocol all command.
• vlan-id — A valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
VLAN Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to attach the VLAN ID “100” to the
protocol-based VLAN group “3.”
console(config-vlan)#protocol group 3 100
To Next Page
Loading...
Need help?
General
