Layer 3 Routing Commands 1785
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example allows no RIP control packets to be sent by VLAN 11.
console(config-if-vlan11)#ip rip send version none
redistribute (RIP)
The redistribute command configures RIP protocol to redistribute routes
from the specified sources. If the source protocol is OSPF, there are five
possible match options.
Syntax
redistribute ospf [metric integer] [match [internal] [external 1] [external 2]
[nssa-external 1] [nssa-external 2]]
no redistribute [ospf | bgp | static | connected]
redistribute {bgp | connected | static} [metric integer]
• metric integer — Specifies the metric to use when redistributing the route.
Range: 0-15.
• match internal — Adds internal matches to any match types presently
being redistributed.
• match external 1 — Adds routes imported into OSPF as Type-1 external
routes into any match types presently being redistributed.
• match external 2 — Adds routes imported into OSPF as Type-2 external
routes into any match types presently being redistributed.
• match nssa-external 1 — Adds routes imported into OSPF as NSSA Type-
1 external routes into any match types presently being redistributed.
• match nssa-external 2 — Adds routes imported into OSPF as NSSA Type-
2 external routes into any match types presently being redistributed.
• static — Redistributes static routes.
To Next Page
Loading...
Need help?
General
