Dell N1100-ON User Manual (English)

To Next Page

To Previous Page

Layer 2 Switching Commands 645

Example

This example sends capture output to the console.

console(config)#monitor capture line

console(config)#exit

console#monitor capture start all

monitor session

Use the monitor session command in Global Configuration mode to

configure the source and destination for mirroring. Packets are copied from

the source to the destination. Use the no form of the command to disable the

monitoring session.

Syntax

monitor session session-number source {interface interface–id |vlan vlan-id

| remote vlan rspan-vlan-id}[rx | tx]

no monitor session session_number source {interface interface–id | vlan

vlan-id | remote vlan rspan-vlan-id}

[no] monitor session session_number destination {interface interface–id

[remove-rspan-tag] | remote vlan rspan-vlan-id}

[no] monitor session session_number filter {ip access-group [acl-name | acl-

number] | mac access-group acl-name}

no monitor session session_number mode

• session-number— Session identification number. (Range: 1-4)

• interface interface–id — Ethernet interface (Range: Any valid Ethernet

Port), CPU interface. CPU interface is not supported as a destination

interface or a source interface for RSPAN.

• vlan vlan-id— The source VLAN identifier. All the ports in this VLAN are

mirrored in the ingress direction only. The source VLAN must not be the

RSPAN VLAN.

• acl-name— An IP or MAC ACL name.

• remote vlan rspan-vlan-id— An RSPAN VLAN configured on the source

switch.

• rx — Mirrors received packets only. If no option specified, monitors both rx

and tx.

Dell N1100-ON User Manual