Layer 3 Routing Commands 1696
Hello Dead Retrax LSA
Admin Router Int. Int. Int. Tranx Ack
Interface Mode Area ID Prior. Cost Val. Val. Val. Delay Intval
------------ -------- ----------- ------ ----- ----- ----- ------ ------ ------
Vl10 Enable 0.0.0.10 1 10 10 40 5 1 1
Vl20 Enable 0.0.0.1 1 10 10 40 5 1 1
Vl100 Enable 0.0.0.111 1 10 10 40 5 1 1
loopback 1 Enable 0.0.0.0 1 1 10 40 5 1 1
show ip ospf interface stats
Use the show ip ospf interface stats command to display the statistics for a
specific interface. The information is only displayed if OSPF is enabled.
Syntax
show ip ospf interface stats vlan vlan-id
• vlan-id — Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the ospf statistics for VLAN 15.
console>show ip ospf interface stats vlan 15
OSPF Area ID....................................... 0.0.0.0
Area Border Router Count................................. 0
AS Border Router Count................................... 0
Area LSA Count........................................... 1
IP Address......................................... 2.2.2.2
OSPF Interface Events.................................... 1
Virtual Events........................................... 0
Neighbor Events.......................................... 0
External LSA Count....................................... 0
To Next Page
Loading...
Need help?
General
