Audio Visual Bridging Commands 1117
Command Mode
Interface Configuration
User Guidelines
This value is the logarithm to the base 2 of the desired mean time interval
between successive Pdelay_req messages sent by the link peer.
IEEE 802.1AS must also be enabled globally as well as on an interface to
become operational.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example configures the switch with an initial log sync interval of 3.
console(config-if-Gi1/0/1)#dot1as interval pdelay 3
console(config-if-Gi1/0/1)#show dot1as interface gi1/0/1
AS Interface Admin Mode................... Enabled
AS Capable................................ No
Is Measuring Delay............................. No
Propagation Delay.............................. 0
Port Role...................................... Disabled
PDELAY Threshold............................... 2500
PDELAY lost responses allowed.................. 3
Neighbor Rate Ratio............................ 0
Initial Sync Interval.......................... 3
Current Sync Interval.......................... -3
Initial Pdelay Interval........................ 3
Current Pdelay Interval........................ 0
Initial Announce Interval...................... 3
Current Announce Interval...................... 0
Sync Receipt Timeout........................... 3
Announce Receipt Timeout....................... 3
dot1as timeout announce
Use this command to configure the number of announce intervals expiries
with no received announce message in which case the master is considered to
be no longer transmitting. Use the no form of the command to return the
announce expiries to the default.
To Next Page
Loading...
Need help?
General
