Layer 2 Switching Commands 366
write-delay: 5000
show ipv6 dhcp snooping interfaces
Use the show ipv6 dhcp snooping interfaces command to show the DHCP
Snooping status of IPv6 interfaces.
Syntax
show ipv6 dhcp snooping interfaces [interface id]
• interface id—A valid physical interface.
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec, Privileged Exec (all show modes)
User Guidelines
If no parameter is given, all interfaces are shown.
Example
(console)#show ipv6 dhcp interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
---------- ------------- ------------- ---------------
Gi1/0/1 No 15 1
Gi1/0/2 No 15 1
Gi1/0/3 No 15 1
show ipv6 dhcp snooping statistics
Use the show ipv6 dhcp snooping statistics command to display IPv6 dhcp
snooping filtration statistics.
To Next Page
Loading...
Need help?
General
