Dell EMC Networking CLI 95
1
Dell EMC Networking CLI
Dell EMC Networking N1100-ON/N1500/N2000/N2100-
ON/N3000/N3100-ON/N4000 Series Switches
Introduction
The Command Line Interface (CLI) is a network management application
operated through an ASCII terminal without the use of a Graphic User
Interface (GUI) driven software application. By directly entering commands,
the user has greater configuration flexibility. The CLI is a basic command-line
interpreter with command-line completion, in-line syntax help, and prior
command recall.
A switch can be configured and maintained by entering commands from the
CLI, which is based solely on textual input and output with commands being
entered by a terminal keyboard and the output displayed as text via a terminal
monitor. The CLI can be accessed from a console terminal connected to an
RS-232 port or through a Telnet/SSH session. Serial communication via a
dedicated USB port is available on the N1100-ON Series switch.
This guide describes how the CLI is structured, describes the command
syntax, and describes the command functionality.
This guide also provides guidelines for configuring the Dell EMC Networking
switch, and provides limited configuration examples. Basic installation is
described in the User’s Guide and must be completed before using this
document.
This document applies to the following switch firmware versions:
• Version 6.3.0.x—N2000, N3000, and N4000 Series switches
• Version 6.3.5.x—N3100-ON Series switches
• Version 6.3.6.x—N2100-ON, and N3100-ON Series switches
• Version 6.4.x.x—N1100-ON Series switches
To Next Page
Loading...
Need help?
General
