Switch Management Commands 2217
Card Index (CID)............... 7
Model Identifier............... Dell 10GBase-T Card
show switch
Use the show switch command to display information about units in the
stack.
Syntax
show switch [stack–member–number | stack–ports[counters | diag | stack-
path {from-unit | all} to unit] | stack–standby]
• unitid—The unit number.
• stack–member–number—The stack member number.
• stack–ports—Display summary stack-port information for all interfaces.
• counters—Display summary data counter information for all interfaces.
• diag—Display front panel stacking diagnostics for each port.
• stack-path—Display the active path from one stacking unit to another.
• From-unit—The unit from which the packets originate.
• All—Displays all unit paths.
• To-unit—The unit to which the packets are sent.
• stack–standby—Display the configured or automatically selected
standby unit number.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
The show switch command shows the configuration and status of the
stacking units, including the active and standby stack management units, the
pre-configured model identifier, the plugged in model identifier, the switch
To Next Page
Loading...
Need help?
General
