Layer 2 Switching Commands 607
no mvr mode
• compatible—Do not allow membership joins on source ports.
• dynamic—Send IGMP joins to the multicast source when IGMP joins are
received on receiver ports.
Default Configuration
The default mode is compatible.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
mvr querytime
Use the mvr querytime command in Global Configuration mode to set the
MVR query response time. The query time is the maximum time to wait for
an IGMP membership report on a receiver port before removing the port from
the multicast group after receiving a leave message. The query time only
applies to receiver ports and is specified in tenths of a second.
Use the no form of the command to set the MVR query response time to the
default value.
Syntax
mvr querytime 1–100
no mvr querytime
Default Configuration
The default value is 5 tenths of a second.
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General
