Switch Management Commands 1846
Commands in this Section
This section explains the following commands:
show sntp configuration
Use the show sntp configuration command to show the configuration of the
Simple Network Time Protocol (SNTP).
Syntax
show sntp configuration
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
Loopback interfaces are not supported on the N1100-ON Series switches.
show sntp configuration sntp trusted-key
show sntp server sntp unicast client enable
show sntp status clock set
sntp authenticate clock timezone hours-offset
sntp authentication-key no clock timezone
sntp broadcast client enable clock summer-time recurring
sntp client poll timer clock summer-time date
sntp server no clock summer-time
sntp source-interface show clock
To Next Page
Loading...
Need help?
General
