Switch Management Commands 1905
User Guidelines
Use the
client-identifier
or
hardware-address
command prior to using this
command for an address pool. Use the
show ip dhcp pool
command to display
pool configuration parameters.
Example
console(config-dhcp-pool)#client-identifier 00:23:12:43:23:54
console(config-dhcp-pool)#host 192.168.21.131 32
ip dhcp bootp automatic
Use the ip dhcp bootp automatic command in Global Configuration mode
to enable automatic BOOTP address assignment. By default, BOOTP clients
are not automatically assigned addresses, although they may be assigned a
static address. Use the no form of the command to disable automatic BOOTP
client address assignment. Use the
show ip dhcp global configuration
command to display the automatic address assignment configuration.
Syntax
ip dhcp bootp automatic
no ip dhcp bootp automatic
Default Configuration
Automatic BOOTP client address assignment is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console#ip dhcp bootp automatic
To Next Page
Loading...
Need help?
General
