Layer 3 Routing Commands 1579
• interval — The number of seconds between successive hello transmissions.
Range: 0–18000 seconds. Default is 30.
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip pim hello-interval 20
ip pim join-prune-interval
The ip pim join-prune-interval command in Interface (VLAN)
Configuration mode to administratively configure the frequency of
join/prune messages on the specified interface. Use the no form of this
command to return the configuration to the default.
Syntax
ip pim join-prune-interval interval
no ip pim join-prune-interval
• interval — The number of seconds between successive join-prune
transmissions. Range: 0–18000 seconds. Default is 60.
Default Configuration
The default join/prune interval is 60 seconds.
Command Mode
Interface (VLAN) Configuration mode
To Next Page
Loading...
Need help?
General
