Switch Management Commands 2249
ip telnet port
The ip telnet port command is used to configure the Telnet TCP port
number on which the switch listens for Telnet connections.
Syntax
ip telnet port port number
• port number — Telnet TCP port number (Range: 1025–65535)
Default Configuration
The default value for the Telnet TCP port is 23.
Command Mode
Global Configuration
User Guidelines
The Telnet server TCP port should not be set to a value that might conflict
with other well-known protocol port numbers used on this switch.
UDP, TCP and RAW ports reserved by the switch and unavailable for use or
configuration are:
Ports 1, 17, 58, 255, 546, 547, 2222, 4567, 6343, 49160
Example
console(config)#ip telnet port 1045
console(config)#no ip telnet port
show ip telnet
The show ip telnet command displays the status of the Telnet server and the
Telnet TCP port number.
Syntax
show ip telnet
Default Configuration
This command has no default configuration.
To Next Page
Loading...
Need help?
General
