Layer 3 Routing Commands 1333
Modified in version 6.3.0.1 firmware.
Example
console#show bgp ipv6 neighbors fe80::1 vlan 10 policy
Neighbor Policy Template
--------------- ------------------------------------------------ -----------
fe80::1%Vl0010
activate
prefix-list jupiter in
prefix-list saturn out
maximum-prefix 2000
send-community
show bgp ipv6 neighbors received-routes
Use this command to display a list of IPv6 routes received from a specific
neighbor. The list includes either all routes received from the neighbor,
received routes that passed inbound policy, or routes rejected by inbound
policy. The output and format as the same as for show IP bgp neighbors
received-routes, except that they list IPv6 routes. Also, the command displays
a list of IPv4 routes received from a specific neighbor with RFC5549.
This command deprecates and replaces the show ipv6 bgp neighbors
received-routes command.
Syntax
show bgp ipv6 neighbors { ipv4-address | ipv6-address [ interface interface-id
] | autodetect interface interface-id } { received-routes | routes | rejected-
routes }
• ipv4-address—The IPv4 address of a BGP peer
• ipv6-address interface interface-id—The IPv6 address of a BGP peer. If the
peer address is an IPv6 link local address, the interface that defines the
scope of the link local address must be given.
•
autodetect interface interface-id
—(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface.
To Next Page
Loading...
Need help?
General
