Layer 2 Switching Commands 711
Class Name Type Proto Reference Class Name
------------------------------- ----- ----- -----------------------------
ipv4 All ipv4
ipv6 All ipv6
stop_http_class All ipv6
match_icmp6 All ipv6
console#show class-map ipv4
Class Name..................................... ipv4
Class Type..................................... All
Class Layer3 Protocol.......................... ipv4
Match Criteria Values
---------------------------- -------------------------------------
Source IP Address 2.2.2.2 (255.255.255.0)
console#show class-map stop_http_class
Class Name..................................... stop_http_class
Class Type..................................... All
Class Layer3 Protocol.......................... ipv6
Match Criteria Values
---------------------------- -------------------------------------
Source IP Address 2001:DB8::0/32
Source Layer 4 Port 80(http/www)
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command to display the current
IEEE 802.1p priority mapping to internal traffic classes for a specific
interface.
Syntax
show classofservice dot1p-mapping [{gigabitethernet unit/slot/port |
port-
channel port-channel-number
| tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
To Next Page
Loading...
Need help?
General
