Layer 3 Routing Commands 1319
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console# show bgp ipv6
BGP table version is 5, local router ID is 20.1.1.1
Status codes: s suppressed, * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Path
*> 2001:DB8::/48 3FFE:100::1 10 100 20 10 i
3FFE:200::4
*> 2001:DB8:4:5::/64 3FFE:100::1 10 100 20 10 ?
show bgp ipv6 aggregate-address
Use this command to display the configured IPv6 aggregate addresses and
indicates if each address is currently active. This command replaces and
deprecates the show ipv6 bgp aggregate-address command.
Syntax
show bgp ipv6 aggregate address-group
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration sub-
modes
User Guidelines
The following fields are displayed.
LocPrf The local preference
Path The AS path
Origin The value of the Origin attribute
To Next Page
Loading...
Need help?
General
