Dell N1100-ON User Manual

Layer 3 Routing Commands 1792
Syntax
interface tunnel tunnel-id
no interface tunnel tunnel-id
• tunnel-id — Tunnel identifier. (Range: 0–7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the interface configuration mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#
show interfaces tunnel
Use the show interfaces tunnel command to display the parameters related to
tunnel such as tunnel mode, tunnel source address and tunnel destination
address.
Syntax
show interfaces tunnel [tunnel-id]
• tunnel-id — Tunnel identifier. (Range: 0–7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes

Dell N1100-ON Specifications

General

Brand	Dell
Model	N1100-ON
Category	Switch
Language	English