Using the CLI 217
2
Using the CLI
Dell EMC Networking N1100-ON/N1500/N2000/N2100-
ON/N3000/N3100-ON/N4000 Series Switches
Introduction
This section describes the basics of entering and editing the Dell EMC
Networking N1100-ON, N1500, N2000, N2100-ON, N3000, N3100-ON, and
N4000 Series Command Line Interface (CLI) commands and defines the
command hierarchy. It also explains how to activate the CLI and implement
its major functions.
This section covers the following topics:
• Entering and Editing CLI Commands
• CLI Command Modes
• Starting the CLI
• Using CLI Functions and Tools
Entering and Editing CLI Commands
A CLI command is a series of keywords and arguments. The total number of
characters that may be entered in a single command is limited to 1536
characters. Keywords identify a command and arguments specify
configuration parameters. For example, in the command show interfaces
status gigabitethernet 1/0/5, show, interfaces and status are keywords;
gigabitethernet is an argument that specifies the interface type, and 1/0/5 is
an argument that specifies the unit/slot/port.
When working with the CLI, the command options are not displayed. The
command is not selected by a menu but is entered manually. To see what
commands are available in each mode or within an Interface Configuration,
the CLI provides a method of displaying the available commands, the
command syntax requirements and in some instances parameters required to
complete the command. The standard command to request context-sensitive
help is the <?> key.
To Next Page
Loading...
Need help?
General
