Switch Management Commands 2169
It is not possible to disconnect the EIA-232 (serial console) session.
exit
Use this command to disconnect the serial connection to a remote unit.
Syntax
exit
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec mode on stack master.
Unit prompt on the stack member.
User Guidelines
This command is available in User Exec mode on the master unit serial port
and from the Unit prompt on member unit serial ports. The user need not be
currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
Example
Example 1:
To disconnect a remote session to a stack member established from the stack
manager.
Stack-Master#connect 2
Remote session started. Type “exit” to exit the session.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>exit
Stack-Master#
Example 2:
To Next Page
Loading...
Need help?
General
