Dell N1100-ON User Manual

Switch Management Commands 1900
client-identifier
Use the client-identifier command in DHCP Pool Configuration mode to
identify a Microsoft DHCP client to be manually assigned an address. Use the
no form of the command to remove the client identifier configuration.
Syntax
client-identifier unique-identifier
no client-identifier
• unique-identifier—The identifier of the Microsoft DHCP client. The
client identifier is specified as 7 bytes of the form
XX:XX:XX:XX:XX:XX:XX where X is a hexadecimal digit.
Default Configuration
This command has no default configuration.
Command Mode
DHCP Pool Configuration mode
User Guidelines
For Microsoft DHCP clients, the identifier consists of the media type
followed by the MAC address of the client. The media type 01 indicates
Ethernet media.
Use the show ip dhcp pool command to display pool configuration
parameters.
Example
console(config-dhcp-pool)#client-identifier 01:03:13:18:22:33:11
console(config-dhcp-pool)#host 192.168.21.34 32
client-name
Use the client-name command in DHCP Pool Configuration mode to specify
the host name of a DHCP client. Use the no form of the command to remove
the client name configuration.

Dell N1100-ON Specifications

General

Brand	Dell
Model	N1100-ON
Category	Switch
Language	English