Layer 2 Switching Commands 334
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay vlan 100
DHCP L2 Relay is Enabled.
DHCP L2 Relay is enabled on the following VLANs:
100
show dhcp l2relay circuit-id vlan
Use the show dhcp l2relay circuit-id vlan command to display whether
DHCP L2 Relay is globally enabled and whether the DHCP Circuit-ID
option is enabled on the specified VLAN or VLAN range.
Syntax
show dhcp l2relay circuit-id vlan vlan-list
•
vlan-list
—
Show information for the specified VLAN range.
List separate, non-
consecutive VLAN IDs separated by commas (without spaces). Use a
hyphen to designate a range of IDs. (Range: 1–4093)
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay circuit-id vlan 300
DHCP L2 Relay is Enabled.
DHCP Circuit-Id option is enabled on the following VLANs:
300
To Next Page
Loading...
Need help?
General
