Layer 2 Switching Commands 432
User Guidelines
This command has no user guidelines.
Example
console #ping ethernet cfm mac 00:11:22:33:44:55 level 1 vlan 10 mpid 1 count
10
traceroute ethernet cfm
Use the traceroute ethernet command to generate a link trace message
(LTM) from the configured MEP.
Syntax
traceroute ethernet cfm {mac mac-addr| remote-mpid 1-8191} {domain
domain name | level 0-7} vlan vlan-id mpid 1-8191 [ttl 1-255]
• level—Maintenance association level
• mac-addr—
The destination MAC address for which the connectivity needs to
be verified. Either MEP ID or the MAC address option can be used.
• remote-mpid—
The MEP ID for which connectivity is to be verified; i.e. the
destination MEP ID.
• domain—
Name of the maintenance domain (an alphanumeric string of up to
43 characters in length).
• vlan-id—
A VLAN associated with the maintenance domain. Range: 1-4093.
• mpid—
The MEP ID from which the loopback message needs to be
transmitted.
• ttl—
The number of hops over which the LTM is expected to be transmitted.
The default number is 64.
Default Configuration
By default, the traceroute command will send loopback trace messages with a
TTL of 64.
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General
