Layer 3 Routing Commands 1659
ip ospf cost
Use the ip ospf cost command in Interface Configuration mode to configure
the cost on an OSPF interface. Use the no form of the command to return
the cost to the default value.
Syntax
ip ospf cost interface-cost
no ip ospf cost
• inte
rface-cost
— Specifies the cost (link-state metric) of the OSPF
interface. (Range: 1–65535)
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan1)#ip ospf cost 5
ip ospf database-filter all out
Use the ip ospf database-filter all out command in Interface Configuration
mode to prevent flooding of OSPF LSAs on an interface.
Use the no form of the command to enable flooding of LSAs on an interface.
Syntax
ip ospf database-filter all out
no ip ospf database-filter all out
To Next Page
Loading...
Need help?
General
