Data Center Technology Commands 1156
Traffic class group 7 is reserved by the system and is not shown.
Auto-configuration ports utilize the traffic class group mappings received
from the auto-configuration source. Manually configured ports enabled for
DCBX transmit the traffic class groups in the ETS TLVs.
Example
The following example demonstrates how to display the global traffic class to
group mappings:
s1# show classofservice traffic-class-group
Traffic Class Traffic Class Group
------------- ---------------------
0 0
1 1
2 1
3 1
4 2
5 1
6 1
show interfaces traffic
Use the show interfaces traffic command to display traffic information.
Syntax
show interfaces traffic [interface-id]
interface-id—A valid physical interface specifier.
Port-channels are not allowed
with this command as the queuing and drops occur on the individual
interfaces and not on the port channel.
Default Configuration
The default is to show the global traffic class group configuration.
Command Mode
Privileged Exec mode
To Next Page
Loading...
Need help?
General
